![]() ![]() There are so many types of tape measure available on the market today, so which should you choose for the job?Įssentially, all tape measures do the same thing. The belt clip simply allows the measuring tape to be hooked onto your belt so you can always have it to hand. If the hook has a hole in it, this is so it can grip onto screws. You may notice that the hook is loose this is intentional to ensure accuracy. The hook, located at the end of the tape comes in handy when measuring hard surfaces such as tables. ![]() Imperial units are usually on the top row and metric measured markings on the bottom. The most important part of your tape measure, the blade (or metallic ribbon) is what gives you your accurate measurements. Simply release the thumb lock to put the tape measure back in its case. It stops your tape from automatically retracting back into its housing when carrying out measurements. The thumb lock is designed to keep your tape in place at your desired length. Use the housing for inside measurements instead of bending the tape. It comes in handy when you want to measure round corn ers. It is essentially the length of the case, but is a great addition to your tape. These stud designations are intended to indicate the "on-center" position of framing members.On the back of the measuring tape, you will find the case length. You will rarely use these markings unless you happen to be building a shed or playhouse, or constructing partition walls during major remodeling projects. These increments correspond to the common intervals for the studs, joists, and rafters that are used to create the basic structural framework for walls, floors, and roofs. Find the Stud Markingsįor the benefit of framing carpenters who do repetitive work, most tape measures also have convenient markings at 16-inch and 19.2-inch increments, usually designated by a number highlighted in red, or by a small diamond marking on the blade. 1/16- and 1/32-inch increments are more often used in fine woodworking projects where hardwood workpieces need to fit very tightly. When framing walls, for example, tolerances down to 1/8-inch are usually completely sufficient to bang studs and joists into place.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |